FUKKOL GILL 6 Circuit Board Protector

FUKKOL GILL 6 Circuit Board Protector
-perfect foe electronical equipment use
-protector for Circuit Board
-anti-corrosion
FUKKOL GILL 6 Circuit Board Protector

Description:
Fukkol Gill 6 is an ideal protective paint for electronic components. It can prevent leakage of electricity and short circuit by forming an insulate and protective film to resist corrosion caused by dilute acid, lye and moisture. Having extreme stability, it iseffective at temperature from -70°C to 90°C.

Benefits:
-Only need to spray 3 layers to provide dielectric resistance against 16KV
-Circuit board sprayed by this product can be coated with tin
-CFC-free
-Forms a highly insulate transparent thin film

Special Guidance:
-Do not puncture or incinerate
-Do not store at temperature above 120°F(49°C)
-Protect from sunlight and high temperature
-Ensure good ventilation while using this product
-Avoid continuously breathing the vapor and aerosol
-Avoid contact with skin and eye
-Breathing protective equipment is required under poor ventilation

Application:
-Protects circuit from corrosion caused by dilute acid, lye and moisture. Resists short circuit and oxidation.
-Remove malfunction of electronic components caused by leakage of electricity, short circuit and corona discharge. Greatly improve quality and stability of electronic products.
-Avoid leakage of electricity and short circuit of EHV transformer
-Protects antenna and V.H.F. from air corrosion. It can also be used to seal antenna joint box, antenna interference eliminating device, antenna filter.
-Marine radio. Protect coil and transformer from leaking electricity. It can make cable and wire insulate and prevent alkali water from corroding components.


Directions:
-Before applying this product, please use Fukkol Electronic Cleaner to thoroughly clean the need-protection surface
-Spray evenly in a distance of 30 cm. For covering the whole surface, apply in a different direction when apllying for the 2nd time.
-To ensure the nozzle unblocked, please hold the can upside down and press the nozzle till aerosol is sprayed out.
-Only need to spray 3 layers to provide dielectric resistance against 16KV. After one layer is sprayed, please wait for 30 minutes before spray another.


Characteristics
Flash point:
10°C(TCC)
Water-Solubility:

Boiling Point:
80°C
Volatility:
86%
odor:

Density of Steam:
>air
Appearance:
transparent
Specific Gravity:
0.90
Dielectric Constant:
≤100KH 1.7 X 10
Tension of Dielectric Breakdown (KV):
14.1
Resistance of Dielectric Breakdown (ohm):
over10
Strength of Dielectric Breakdown (KV):
20.4